This would basically be just like doing multiple lofts at once and I think could be a better workflow than making a bunch of smaller lofts. There are quite a few posts asking how to do it like this one.Įven in the more generalized problem where there is more than one enclosed region in the profiles, Fusion could just prompt the user pick the pairs of enclosed regions to tell Fusion how to make the loft. I think it's a common enough use case for lofts that it would be worth it. This case is pretty easy to solve as I explained in my post, and could be automated. Are you ready to build your very first 3D model in 2019 with Autodesk Fusion 360 This is the perfect course to start with. Think of making custom tubing like that used in custom bicycle frames and the like. Ashley Elmer, an ergonomic pillow supports the alignment of the spine and alleviates pressure points that can occur from being in one position. On the other hand, it's a pretty common case to try to loft between two profiles that each have only one enclosed region inside them, like two concentric circles for instance. According to perinatal and pediatric chiropractor Dr. However, I don't imagine that many people would be trying to loft between two sketches that look like swiss cheese. Yes, if we're talking about the most general problem - creating a loft with any number of enclosed regions within each-other - then that is much more complex and gets into a lot of topology questions. ![]() I'm considering this to be the most common special case of a more generalized problem.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |